What are the ways to avoid excess cooling tower capacity?

What are the ways to avoid excess cooling tower capacity?

In any production, we pay attention to energy saving and consumption reduction. Of course, we should also deal with specific problems. Different objects must use different methods. So how can we effectively avoid the problem of overcapacity in closed cooling towers?

Closed cooling tower fans are used to circulate the water system. Of course, from the perspective of the number of equipment and maintenance power consumption, the closed cooling tower fans account for a large proportion. To control the excess capacity of closed cooling towers, there are the following methods.

Control the height of the cross-flow cooling tower's packing to the fan to be greater than or equal to 0.2 times the fan diameter.

的 The height from the top surface of the counterflow cooling tower packing to the airflow contraction section between the wind cylinders must meet the following requirements:

If the top cover is flat, the top angle should be less than 90 degrees from the top surface of the filler. If there is a deflector under the top cover, the angle from the top surface of the water collector can be 90 degrees to 110 degrees.

If it is contracted, then his angle should be best from 90 degrees to 110 degrees.

Cross-flow cooling towers should have flow-through measures to prevent air from entering the bottom of the packing and shorting to the water surface.

The above is just a brief introduction of the three methods, but they are the points that we should pay attention to in our use, I hope to help everyone